Online timer for 10 minutes
You are circling the small sheep pen again, checking the rails, wire and gate after the first pass left something uncertain. A fresh 10 minutes gives you enough space to revisit the loose-looking sections while the sheep shift around you. Keep moving steadily rather than lingering at the first problem; the second circuit is for confirming what holds, spotting a gap you missed, and noting any repair that needs more tools.
On this second circuit of the pen, leave the countdown visible if you need to glance at the remaining time between fence sections. Closing its tab or browser may stop it or clear the running countdown, depending on the phone and browser, so the finish signal might never sound. If you must use another page, switch tabs without closing this one, then return after checking the gate latch or the far corner.
Back at the pen when the signal interrupts you, pause long enough to identify the exact rail, wire strand or latch you were examining. Mark that point mentally before dealing with a sheep crowding the gate, then resume from there instead of starting another full circuit. Damp ground, long grass and uneven hill-country fencing can slow the check; if the circuit is complete early, use the remaining moments to watch whether the gate stays settled as the flock moves nearby.
Common questions
What might make the allotted pen check take longer than planned?
Wet ground, thick grass or sheep pressing near the gate can slow a second circuit. Stop at the signal and note the unchecked section rather than rushing over it.
What should I do if the small pen is checked before the interval ends?
Use the remaining time to watch the flock move against the fence and confirm that the latch stays closed. If nothing shifts or bows, the check can finish early.
Cookie policy